This rotisserie
motor has been going
almost non stop for a bit over 100 days and the metal case is paying
the price.
At first I thought the noise
of metal rubbing on metal might help with the deterrent factor, and it
didn't seem to be all that much resistance...but I guess constant
pressure can wear anything or anybody down to the point of damage if
the issue gets pushed long enough.
I need to go back to the
drawing board and figure out some way of decreasing the friction. The
above motor was shut down before I did any real damage, but some TLC
along with a few adjustments are called for before it can go back to
the front line.